APPLICATION INSTRUCTIONS

How to Apply your Rhinestone or Vinyl Decal

VINYL DECALS

Step 1 – Clean the area thoroughly with rubbing alcohol or soap and water. Let surface dry completely.

Step 2 – Prepare the decal for application by firmly rubbing a squeegee or credit card across the clear transfer tape. This removes any air bubbles that may have formed since shipping and makes the decal cling to the transfer tape.

Step 3 – Peel the white paper backing off the decal. If the decal clings to the backing, slowly replace the paper backing and repeat Step 2.

Step 4 – Slowly lower the decal onto the surface and firmly rub it in place with a squeegee or credit card.

Step 5 – Slowly peel the clear transfer tape off at an angle. Be careful not to pull the decal off the surface. If decal pulls away from the surface repeat Step 4.

ADDITIONAL INFORMATION:
If you develop any air bubbles, use a pin to poke in the center and push the air out through the hole. For best results do not apply a decal in extreme hot or cold temperatures. Always apply in a shaded area out of direct sunlight.

RHINESTONE CAR DECALS

Step 1 – Thoroughly clean and dry the area where you want to place your new decal. Let the surface dry completely.

Step 2 – Peel away the milky white opaque backing. Try not to bend or stretch the decal.

Step 3 – Line up where you want the decal positioned but do not let it touch the surface until you are 100% ready to apply.

Step 4 – When ready, carefully press decal down onto the surface (working from center out) and push firmly in place.

Step 5 – Enjoy your new decal!

ADDITIONAL INFORMATION:
If design has multiple parts, each piece must be placed individually. We recommend starting with the largest piece and then add the others.

This is a one-time use decal. Once the decal is adhered to surface you will not be able to move or remove it without damaging the decal. Do NOT use on retractable windows, windshields or in the path of a wiper.

To remove, gently peel the decal away from the surface. If there is any leftover residue remove with razor blade.